This forge comes complete. All you need is an LP tank. Setup usually takes less than 10 minutes and is very simple. Full setup instructions are included. With a little care the liners normally last many years. However if you should need to replace the liner it only requires removal of a couple pins and you have full access to the liner.
DEWALT 20-Volt Max Lithium Ion (Li-ion...
DEWALT 20-Volt Max Lithium Ion (Li-ion) 1/2-in Cordless Drill with Battery and Soft Case
For the ability to complete a wide range of applications, this 20-volt drill sports a high-performance motor to get the job done. The variable-speed motor delivers 0-450/1,500-RPM for better control over a variety of drilling and fastening tasks, while 16 clutch settings allow you to adjust torque to prevent overdriving or stripping of fasteners. The 1/2-in single-sleeve ratcheting chuck provides a tight grip for bit stability during heavy-duty applications. The lightweight design and comfortabl
Details about Blacksmith tongs and a...
Details about Blacksmith tongs and a twisting wrench
eBay item number:
Seller assumes all responsibility for this listing.
Country/Region of Manufacture:
Three pair of tongs and a twisting wrench: 1 pair of 1/2" bolt tongs, 1 pair of tongs for 3/8" flat stock, 1 pair of tongs for 1/4" flat stock and a twisting wrench for decorative twists. Tongs are approximately 16" in length. Thanks 4lookin.
Questions and answers about this item
No questions or answers have been posted about this item.
Ask a question
1/2" Box Jaw-U Tongs8650 steel, flat 12" handles with balls on the ends, jaws are made so that the stock is held on edge by both sides of the tongs.
Available in the following sizes:(all are 1/2" x ##) 3/4, 1, 1 1/4, 1 1/2, 1 3/4, 2, 2 1/4, 2 1/2
Specify Size in drop down box below when ordering.
Centaur 1/4 x 3/8 Offset Box Jaw Tongs...
Centaur 1/4 x 3/8 Offset Box Jaw Tongs, 12 Rein Length
The box jaw tongs are meant for holding flat bar stock. All Centaur Forge tongs are made from lightweight 8560 grade steel. They feature balls at the end of the reins for maximum control.
14-1/4" Overall Length - 12" Rein Length - 1-3/4" Mouth Depth
New Jersey Steel Baron, LLC was created by Aldo Bruno to provide the high-quality knife blade steels and resources necessary to produce the blades, swords, and other art being created by modern day knife-makers. We pride ourselves on our dedication to the individual, whether new to a forge or master smith. By creating lasting relationship it is our hope to better connect each of you to the education, information, and materials needed to continue in a craft so many have come to love, che
Details about Blacksmith Bottom Swage...
Details about Blacksmith Bottom Swage Anvil Tool 3/4" Hardy
The tool you're bidding on is approx.3 3/4" high including the hardy post and 2 1/2" long and 1 1/4" across the forming surface. This tool is used by many different craftsman in lots of different trades to form and swage materials. This tool can be used with a top set or ball pien hammers to bend draw and tennon materials and any other free forming you may come up with. The tool is made of tough 60/45/18 ductile iron. These castings have been produced for many years and have proven to be very re